Show Ip Igmp Snooping - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show ip igmp snooping

Use the show ip igmp snooping command to display Internet Group Management Protocol (IGMP)
snooping information. Variations of this command include:
show ip igmp snooping
show ip igmp snooping mrouter
show ip igmp snooping mrouter vlan <vlan id>
show ip igmp snooping vlan
show ip igmp snooping vlan <vlan id>
Global IGMP snooping overrides the virtual local area network (VLAN) IGMP snooping.
If global snooping is disabled, you cannot enable VLAN IGMP snooping. If global
snooping is enabled, you can enable or disable VLAN IGMP snooping. Refer to
snooping on page 1035
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
mrouter
vlan
vlan <vlan id>
Default Values
No default values are necessary for this command.
Command History
Release 12.1
Release 17.1
60000CRG0-35E
for more information.
Optional. Displays the ports associated with multicast routers.
Optional. Displays whether IGMP snooping is enabled or disabled for all
VLANs.
Optional. Displays whether IGMP snooping is enabled or disabled for a
particular VLAN.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
ip igmp
559