ADTRAN AOS Version R10.1.0 Command Reference Manual page 717

Command Reference Guide
show ramdisk
Use the show ramdisk command to display a list of all files currently stored in volatile random access
memory (RAM) disk memory or details about a specific file stored in RAM disk memory. Variations of
this command include:
show ramdisk
show ramdisk <filename>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Not all units are capable of using a RAM disk file system. Use the show ? command to
display a list of valid commands at the enable prompt.
Syntax Description
<filename>
Default Values
No default values are necessary for this command.
Command History
Release 17.7
Usage Examples
The following is sample show ramdisk output displaying the contents of the RAM disk, space occupied by
each file, the total RAM disk space allocated, available space, and used space:
>enable
#show ramdisk
10005125 NV3130A-17-07-00-26-AE.biz
10007923 bytes used, 7429514 available, 17437437 total
60000CRG0-35E
Optional. Displays details for a specified file located in RAM disk file
system. Enter a wildcard (such as *.biz) to display the details for all files
matching the entered pattern.
Command was introduced for AOS units limited to only 16 Megabytes of
flash memory.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
717