ADTRAN AOS Version R10.1.0 Command Reference Manual page 757

Command Reference Guide
Functional Notes
The stack candidates are a list of units that could be added to the stack. They are not yet members.
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
page 837).
Usage Examples
The following example displays the configuration of the switch stack while in stack-master mode:
>enable
#show stack
Stack mode is MASTER
Management Vlan is 2386, firmware version is 08.00.18.D
Stack network is 169.254.0.0/24
Stack members...
Member Mac Address
2 00:A0:C8:02:CF:C0
3 00:A0:C8:00:8C:20
#
Member
Mac Address
Mgmt IP Address
Source Interface
State
The following example displays the configuration of the switch stack while in stack-member mode:
>enable
#show stack
Stack mode is STACK-MEMBER
My Unit ID is 3, management Vlan is 2386
Stack management network is 169.254.0.0/24
Stack Master info:
Master is "Switch", learned via giga-eth 0/1
IP address is 169.254.0.1, MAC address is 00:DE:AD:00:65:83
#
60000CRG0-35E
Mgmt IP Address Source Interface
169.254.0.2 Stack port
169.254.0.3 Stack port
Specifies the stack member's Unit ID.
Specifies the stack member's medium access control (MAC) address.
Specifies the stack member's IP address.
Specifies the interface that the stack member was learned from.
Specifies the stack member's state: Up (member is up and functioning
properly); Down (member was at one time functioning, but contact has
been lost); Waiting (waiting for the unit to register; when registered, it will
be added to the stack); Denied (the unit could not be added to the stack
because the stack protocol versions were not compatible).
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
terminal length <number> on
State
Up
Up
757