ADTRAN AOS Version R10.1.0 Command Reference Manual page 977

Command Reference Guide
Hardware access maps are not active until they are applied to a VLAN. For instructions on how to apply an
access map to a VLAN, refer to
Changing hardware ACL or hardware access map configuration or application causes
new information to be reinstalled on the hardware. It is possible to run out of hardware
resources depending on how many resources are needed to apply the desired change. If
there are not enough hardware resources to install the new criteria in the hardware, an
error message is displayed. You can view the amount of hardware resources available
using the command
60000CRG0-35E
vlan <vlan id> on page
show hw-filter-resource on page
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1375.
518.
977