ADTRAN AOS Version R10.1.0 Command Reference Manual page 1031

Command Reference Guide
ip ftp source-interface <interface>
Use the ip ftp source-interface command to use the specified interface's IP address as the source IP
address for File Transfer Protocol (FTP) traffic transmitted by the unit. Use the no form of this command if
you do not wish to override the normal source IP address.
Syntax Description
<interface>
Default Values
No default values are necessary for this command.
Command History
Release 6.1
Release 9.1
Release 14.1
Release 15.1
Release 17.1
Release A4.01
Release A5.01
Functional Notes
This command allows you to override the sender field in the IP packet. If you have multiple interfaces in
your unit, changing the sender tells the receiver where to send replies. This functionality can also be used
to allow packets to get through firewalls that would normally block the flow.
Usage Examples
The following example configures the unit to use the loopback 1 interface as the source IP for FTP traffic:
(config)#ip ftp source-interface loopback 1
60000CRG0-35E
Specifies the interface to be used as the source IP address for FTP traffic.
Specify an interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface id | ap |
ap/radio | ap/radio.vap]>. For example, for a T1 interface, use t1 0/1; for an
Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for an
ATM subinterface, use atm 1.1; and for a wireless virtual access point, use
dot11ap 1/1.1. Type ip ftp source-interface ? for a complete list of valid
interfaces.
Command was introduced.
Command was expanded to include the high level data link control (HDLC)
interface.
Command was expanded to include the tunnel interface.
Command was expanded to include the bridged virtual interface (BVI).
Command was expanded to include the asynchronous transfer mode (ATM)
interface.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface.
Command was expanded to include the Gigabit Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1031