ADTRAN AOS Version R10.1.0 Command Reference Manual page 561

Command Reference Guide
show ip interfaces
Use the show ip interfaces command to display the status information for all Internet Protocol version 4
(IPv4) interfaces (or a specific IPv4 interface). Variations of this command include:
show ip interfaces
show ip interfaces <interface>
show ip interfaces <interface> brief
To view secondary IP addresses, use the show running-config command.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<interface>
brief
Default Values
No default values are necessary for this command.
Command History
Release 1.1
Release 9.1
Release 11.1
Release 17.1
60000CRG0-35E
Optional. Displays status information for a specific IPv4 interface. Specify
an interface in the format <interface type [slot/port | slot/port.subinterface id
| interface id | interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For
example, for a T1 interface, use t1 0/1; for an Ethernet subinterface, use
eth 0/1.1; for a PPP interface, use ppp 1; for an ATM subinterface, use
atm 1.1; and for a wireless virtual access point, use dot11ap 1/1.1. Type
show ip interfaces ? for a complete list of applicable interfaces. If no
interface is specified, status information for all interfaces is displayed.
Optional. Displays an abbreviated version of interface statistics for all IPv4
interfaces.
Command was introduced.
Command was expanded to include the high level data link control (HDLC)
and tunnel interfaces.
Demand interface was added.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
561