ADTRAN AOS Version R10.1.0 Command Reference Manual page 697

Command Reference Guide
show port-security
Use the show port-security command to display port security information. Variations of this command
include:
show port-security
show port-security address
show port-security interface <interface>
show port-security interface <interface> address
show port-security port-expiration
show port-security port-expiration detailed
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
address
interface <interface>
port-expiration
detailed
Default Values
No default values are necessary for this command.
Command History
Release 8.1
Release 17.1
Release 18.3
60000CRG0-35E
Optional. Displays a list of secure medium access control (MAC) addresses
for all interfaces currently configured for port security.
Optional. Filters the output to include only information for the specified
interface. Specify an interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface id | ap |
ap/radio | ap/radio.vap]>. For example, for a T1 interface, use t1 0/1; for an
Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for an
ATM subinterface, use atm 1.1; and for a wireless virtual access point, use
dot11ap 1/1.1. Type show port-security interface ? for a complete list of
valid interfaces.
Optional. Displays the ports currently participating in port expiration and the
amount of time left until the port is shut down.
Optional. Displays information for all interfaces, even if not configured for
port expiration.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Command was expanded to include the xgigabit-switchport interface.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
697