ADTRAN AOS Version R10.1.0 Command Reference Manual page 204

Command Reference Guide
copy ramdisk
Use the copy ramdisk command to copy files located in the volatile RAM disk memory to a specified
destination. Variations of this command include:
copy ramdisk <source file> flash
copy ramdisk <source file> flash <new file>
copy ramdisk <source file> overwrite primary
copy ramdisk <source file> overwrite primary verify
copy ramdisk <source file> overwrite secondary
copy ramdisk <source file> overwrite secondary verify
copy ramdisk tftp
copy ramdisk xmodem
Not all units are capable of using a RAM disk file system. Use the copy ? command to
display a list of valid commands at the enable prompt.
Syntax Description
<source file>
flash
flash <new file>
overwrite primary
overwrite secondary
tftp
60000CRG0-35E
Specifies the name of the file (located on the RAM disk) to copy.
Copies the specified file and saves it to the system flash memory using the
same file name.
Copies the specified file and saves it to the system flash memory using the
specified file name.
Replaces the primary boot image file with the file from RAM disk. The file to
be overwritten is deleted prior to copying the new file. In order for this
command to succeed, the RAM disk must be mounted, the specified file
must exist, and the specified file must verify with a valid signature for the
unit.
Replaces the secondary boot image file with the file from RAM disk. The file
to be overwritten is deleted prior to copying the new file. In order for this
command to succeed, the RAM disk must be mounted, the specified file
must exist, and the specified file must verify with a valid signature for the
unit.
Copies the specified file from the RAM disk to a specified Trivial File
Transfer Protocol (TFTP) server.
After entering the command, AOS prompts for the following information:
Address of remote host: Specifies the IP address of the TFTP server.
Source filename:
Destination filename:
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
Specifies the name of the file (located on the
RAM disk) to copy to the TFTP server.
Specifies the file name to use when storing the
copied file on the TFTP server. (The file will be
placed in the default directory established by the
TFTP server.)
204