ADTRAN AOS Version R10.1.0 Command Reference Manual page 704

Command Reference Guide
realtime
Default Values
No default values are necessary for this command.
Command History
Release 13.1
Release 17.1
Release 17.2
Functional Notes
A probe must be created first using the probe command. Issuing the shutdown command at the probe
configuration prompt will disable a probe, causing it to cease traffic generation. While a probe is shutdown,
it will not fail.
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
page 837).
Usage Examples
The following is sample output of the show probe probe_A command:
>enable
#show probe probe_A
Current State: PASS Admin. Status: DOWN
Type: ICMP Echo Period: 30 sec Timeout: 500 msec
Hostname: www.adtran.com
Tracked by: track_1
Tests Run: 121 Failed: 0
Time in current state: 25 days 2 hours, 34 minutes, 32 seconds
The following is sample output of the show probe responder twamp command:
>enable
#show probe responder twamp
0--------------1----------------2----------------3----------------4---------------5----------------6----------------7---------------8
12345678901234567890123456789012345678901234567890123456789012345678901234567890
TWAMP-Test: 360 rcvd, 360 sent
TWAMP-Control: 20 sessions opened, 18 sessions closed,
3 sessions rejected, 2 sessions active
60000CRG0-35E
Optional. Displays full-screen output in real time. Refer to the Functional
Notes below for more information.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Command was expanded to include the probe responder options.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
terminal length <number> on
704