Table of Contents
Advertisement
Command Reference Guide
ip policy-class <name> max-host-sessions <number>
Use the ip policy-class max-host-sessions command to create or alter settings for an access control policy
(ACP). For more details on ACP functionality in AOS, refer to the
Set on page
3144. Use the no form of this command to return to the default value.
Syntax Description
<name>
<number>
Default Values
By default, all AOS security features are disabled and there are no configured ACP entries.
Command History
Release 12.1
Usage Examples
The following example allows no more than 100 policy sessions to be sourced from a single host IP
address on the ACP named PRIVATE:
(config)#ip policy-class PRIVATE max-host-sessions 100
60000CRG0-35E
Identifies the configured ACP using an alphanumeric descriptor (maximum
of 50 characters). All ACP descriptors are case sensitive.
Specifies the maximum number of allowed ACP sessions that can be
created from each unique source address. This command is used in
conjunction with a named ACP and only applies the limit to that particular
ACP.
The number must be within the appropriate range limits. The limits depend
on the type of AOS device being used. Setting this value to 0 restores the
default setting. By default, this feature is turned off (meaning no limits per
source address will be enforced).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
IPv4 Access Control Policy Command
1060
Advertisement
Table of Contents
