Show Lldp Interface - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show lldp interface

Use the show lldp interface command to display Link Layer Discovery Protocol (LLDP) configuration
and statistics for interfaces on this device. Variations of this command include:
show lldp interface
show lldp interface <interface>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<interface>
Default Values
No default values are necessary for this command.
Command History
Release 8.1
Release 17.1
Release A4.01
Release A5.01
60000CRG0-35E
Optional. Displays the information for the specified interface. Specify an
interface in the format <interface type [slot/port | slot/port.subinterface id |
interface id | interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For
example, for a T1 interface, use t1 0/1; for an Ethernet subinterface, use
eth 0/1.1; for a PPP interface, use ppp 1; for an ATM subinterface, use
atm 1.1; and for a wireless virtual access point, use dot11ap 1/1.1. Type
show lldp interface ? for a complete list of applicable interfaces.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface.
Command was expanded to include the Gigabit Ethernet and Gigabit
Switchport interfaces.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
650