ADTRAN AOS Version R10.1.0 Command Reference Manual page 521

Command Reference Guide
eth 0/14 Admin Up
eth 0/15 Admin Up
eth 0/16 Admin Up
eth 0/17 Admin Up
eth 0/18 Admin Up
eth 0/19 Admin Up
eth 0/20 Admin Up
eth 0/21 Admin Up
eth 0/22 Admin Up
eth 0/23 Admin Up
eth 0/24 Admin Up
giga-eth 0/1 Admin Up
giga-eth 0/2 Admin Up
The following is sample output from the show interfaces gigabit-switchport command:
>enable
#show interfaces gigabit-switchport 0/1
giga-swx 0/21 is UP, line protocol is UP
Hardware address is 00:A0:C8:00:24:4F
RJ-45 Shielded
100Mb/s, negotiated full-duplex, configured full-duplex
ARP type: ARPA; ARP timeout is 20 minutes
5 minute input rate 6232 bits/sec, 10 packets/sec
5 minute output rate 344 bits/sec, 0 packets/sec
3432 packets input, 237372 bytes
6 unicasts, 1 broadcasts, 3067 multicasts input
0 unknown protocol, 2781 discards
0 input errors, 0 crc errors
358 packets output, 28552 bytes
7 unicasts, 0 broadcasts, 351 multicasts output
0 output errors, 0 deferred, 0 discards
0 single, 0 multiple, 0 late collisions
0 excessive collisions
L3 Switch
25 packets input, 25 packets forwarded
0 header errors, 0 discards
The following is sample output from the show interfaces switchport command:
>enable
#show interfaces switchport
Name: eth 0/1
Switchport: enabled
Administrative mode: access
Negotiation of Trunking: access
60000CRG0-35E
Line Up Desk 14
Line Up Desk 15
Line Up Desk 16
Line Up Desk 17
Line Up Desk 18
Line Up Desk 19
Line Up Desk 20
Line Up Desk 21
Line Up Desk 22
Line Up Desk 23
Line Up Desk 24
Line Up Uplink Trunk
Line Down Unused
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
521