ADTRAN AOS Version R10.1.0 Command Reference Manual page 208

Command Reference Guide
http <url>
https <url>
non-dynvoice-config
ramdisk
startup-config
tftp
usbdrive0
xmodem
Default Values
No default values are necessary for this command.
Command History
Release 8.1
Release 16.1
Release 17.7
Release 18.2
Usage Examples
The following example copies the current running configuration to the startup configuration located in flash
memory:
>enable
#copy running-config flash startup-config
Building configuration...
Done. Success!
60000CRG0-35E
Copies the current running configuration file or newly stored dynamic voice
configuration file, and transfers it to a Hypertext Transfer Protocol (HTTP)
server using the specified HTTP server uniform resource locator (URL).
Uses the HTTP PUT operation.
Copies the current running configuration file and transfers it to a secure
socket Hypertext Transfer Protocol Secure (HTTPS) server using the
specified HTTPS server URL. Uses the HTTPS PUT operation.
Copies the current nondynamic portion of the voice running configuration
and saves it to the nondynamic voice configuration file.
Copies current running configuration to the volatile RAM disk.
Replaces the startup configuration (located in either CompactFlash or
system flash) with a copy of the current running configuration.
Copies the current running configuration or newly stored dynamic voice
configuration file to the specified Trivial File Transfer Protocol (TFTP)
server.
After entering copy running-config tftp or copy running-config
dynvoice-config tftp, AOS prompts for the following information:
Address of remote host:
Destination filename:
Copies current running configuration to the USB flash drive memory.
Copies the current running configuration (using the XMODEM protocol) to
the terminal connected to the console port. XMODEM capability is provided
in VT100 terminal emulation software, such as HyperTerminal.
Command was introduced.
Command was expanded to include HTTP and HTTPS.
Command was expanded to include the ramdisk parameter.
Command was expanded to include USB flash drive memory.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
Specifies the IP address of the TFTP server.
Specifies the file name to use when storing the
copied file on the TFTP server. (The file will be
placed in the default directory established by the
TFTP server.)
208