ADTRAN AOS Version R10.1.0 Command Reference Manual page 649

Command Reference Guide
show lldp device <name>
Use the show lldp device command to display neighbor information about an adjacent device on the same
IEEE 802 local area network (LAN).
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<name>
Default Values
No default values are necessary for this command.
Command History
Release 8.1
Release 17.1
Functional Notes
If there is more than one neighbor with the same system name, all neighbors with that system name will be
displayed.
Usage Examples
The following example shows specific information about a neighbor for the system name Router:
>enable
#show lldp device Router
Chassis ID: 00:A0:C8:02:DD:2A (MAC Address)
System Name: Router
Device Port: eth 0/1 (Locally Assigned)
Holdtime: 30
Platform: NetVanta 3305
Software: Version: 08.00.22.sw1.D, Date: Mon Nov 01 10:28:55 2004
Capabilities: Bridge, Router
Enabled Capabilities: Router
Local Port: eth 0/3
Management Addresses:
Address Type: IP version 4, Address: 10.23.10.10
60000CRG0-35E
Specifies the system name of the neighbor to display.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
649