ADTRAN AOS Version R10.1.0 Command Reference Manual page 276

Command Reference Guide
debug ip dhcp client
Use the debug ip dhcp client command to activate debug messages associated with Dynamic Host
Configuration Protocol version 4 (DHCPv4) client operation in AOS. Debug messages are displayed (real
time) to the terminal (or Telnet) screen. Use the no form of this command to disable the debug messages.
Variations of this command include:
debug ip dhcp client
debug ip dhcp client <interface>
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
<interface>
Default Values
By default, all debug messages in AOS are disabled.
Command History
Release 2.1
Release 16.1
Release A4.01
Release 18.3
Release R10.1.0
Functional Notes
The debug ip dhcp client command activates debug messages to provide information on DHCPv4 client
activity in AOS. The AOS DHCPv4 client capability allows interfaces to dynamically obtain an IPv4 address
from a network DHCPv4 server.
Usage Examples
The following example activates debug messages associated with DHCPv4 client activity:
60000CRG0-35E
Optional. Specifies an interface to which an IPv4 address can be assigned
in the format <interface type [slot/port | slot/port.subinterface id | interface id
| interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For example, for
an Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for
an ATM subinterface, use atm 1.1; and for a wireless virtual access point,
use dot11ap 1/1.1. Type debug ip dhcp-client ? for a list of valid
interfaces.
Command was introduced.
Command was expanded to include the interface parameter.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface.
Command syntax was changed to remove the hyphen (from dhcp-client)
for ADTRAN internetworking products.
Command syntax was changed to remove the hyphen (from dhcp-client)
for ADTRAN voice products.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
276