ADTRAN AOS Version R10.1.0 Command Reference Manual page 821

Command Reference Guide
show voice trunk
Use the show voice trunk command to display all voice trunks. Variations of this command include:
show voice trunk
show voice trunk <trunk id>
show voice trunk connects <trunk id>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
connects
<trunk id>
Default Values
No default values are necessary for this command.
Command History
Release 10.1
Release 17.1
Usage Examples
The following example displays all voice trunks:
>enable
#show voice trunk
Busy
Trunk Resource Admin.
Name Selection Config.
--------------------------------------------------------------------------------------------------------------------------------------------
T01 linear Not Busy
T06 linear Not Busy
T02 linear Not Busy
T03 linear Not Busy
60000CRG0-35E
Optional. Displays all trunk voice interface connections.
Optional. Displays voice trunk information for a specific trunk ID. Use T01,
T02, and so on for the trunk ID.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Busy Busy
Admin. Attempts
Status Today
Not Busy 0
No Connects 0
Not Busy 0
No Connects 0
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
Non Busy Busy
Attempts Attempts Attempts
Today Total
0 0
0 0
0 0
0 0
Non Busy
Total
7
0
27
0
821