ADTRAN AOS Version R10.1.0 Command Reference Manual page 974

Command Reference Guide
http source-interface <interface>
Use the http source-interface command to specify a source interface for Hypertext Transfer Protocol
(HTTP) traffic originated by the AOS unit. The IP address of the specified interface will be used to source
all HTTP traffic. Use the no form of this command if you do not wish to override the default source IP
address.
This command pertains to the HTTP client and not the HTTP server.
Syntax Description
<interface>
Default Values
By default, no HTTP source interface is defined.
Command History
Release 16.1
Release 17.1
Release A4.01
Release A5.01
Release 18.3
Release R10.1.0
Functional Notes
This command allows you to override the sender field in the IP packet. If you have multiple interfaces in
your unit, changing the sender tells the receiver where to send replies. This functionality can also be used
to allow packets to get through firewalls that would normally block the flow.
60000CRG0-35E
Specifies the source interface for HTTP traffic. Specify an interface in the
format <interface type [slot/port | slot/port.subinterface id | interface id |
interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For example, for
a T1 interface, use t1 0/1; for an Ethernet subinterface, use eth 0/1.1; for a
PPP interface, use ppp 1; for an ATM subinterface, use atm 1.1; and for a
wireless virtual access point, use dot11ap 1/1.1. Type ip http
source-interface ? for a complete list of valid interfaces.
Command was introduced.
Command was expanded to include the asynchronous transfer mode (ATM)
interface.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface.
Command was expanded to include the Gigabit Ethernet interface.
Command syntax was changed to remove the ip keyword for IPv6 support
in ADTRAN internetworking products.
Command syntax was changed to remove the ip keyword for ADTRAN
voice products.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
974