ADTRAN AOS Version R10.1.0 Command Reference Manual page 744

Command Reference Guide
show snmp
Use the show snmp command to display the system Simple Network Management Protocol (SNMP)
current configuration. Variations of this command include the following:
show snmp engineID
show snmp group
show snmp user
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
engineID
group
user
Default Values
No default values are necessary for this command.
Command History
Release 1.1
Release 13.1
Release 17.1
Usage Examples
The following is sample output from the show snmp command for a system with SNMP disabled, and the
default chassis and contact parameters:
>enable
#show snmp
Chassis: Chassis ID
Contact: Customer Service
0 Rx SNMP packets
0 Bad community names
0 Bad community uses
0 Bad versions
0 Silent drops
60000CRG0-35E
Displays the hex string that defines the current local engine ID settings.
Displays the list of all groups entered.
Displays the list of all users entered.
Command was introduced.
Command was expanded to include the engineID, group, and user
options.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
744