ADTRAN AOS Version R10.1.0 Command Reference Manual page 596

Command Reference Guide
show ip route-cache express host-table
Use the show ip route-cache express host-table command to display the hardware host entries currently
used to route packets to directly connected networks in Layer 3 switching. Variations of this command
include:
show ip route-cache express host-table
show ip route-cache express host-table count
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
count
Default Values
No default values are necessary for this command.
Command History
Release 17.5
Usage Examples
The following is sample output from the show ip route-cache express host-table command:
>enable
#show ip route-cache express host-table
DESTINATION MAC ADDRESS
-------------------------------------------------------------------------------------------
10.23.131.254 00:A0:C8:00:7E:D3
20.1.1.2 00:DE:AD:00:55:55
21.1.1.2 00:A0:C8:00:78:A8
22.1.1.2 00:A0:C8:24:7E:6A
60000CRG0-35E
Optional. Specifies the output is limited to the number of entries stored in
the Address Resolution Protocol (ARP) table.
Command was introduced.
INTERFACE
vlan 1
vlan 20
vlan 21
vlan 22
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
596