ADTRAN AOS Version R10.1.0 Command Reference Manual page 493

Command Reference Guide
show ethernet cfm stack
Use the show ethernet cfm stack command to display statistics and information about the Ethernet
operations, administration, and maintenance (OAM) connectivity fault management (CFM) stack.
Variations of this command include:
show ethernet cfm stack
show ethernet cfm stack interface <interface>
show ethernet cfm stack level <level>
show ethernet cfm stack vlan <vlan id>
show ethernet cfm stack vlan none
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
interface <interface>
level <level>
vlan <vlan id>
none
Default Values
By default, all interfaces are displayed.
By default, all maintenance levels are displayed.
By default, all VLANs are displayed.
60000CRG0-35E
Optional. Specifies that output is limited to the specified interface. Specify
an interface in the format <interface type [slot/port | slot/port.subinterface id
| interface id | interface id. subinterface id]>. For example, for an Ethernet
subinterface, use eth 0/1.1. For a list of appropriate interface, enter
interface ? at the prompt.
Optional. Specifies that output is limited a specified maintenance level.
Levels range from 0 to 7.
Optional. Specifies that output is limited to a specific virtual local area
network (VLAN). VLAN ID range is 1 to 4095.
Optional. Specifies that output is limited to all VLANs.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
493