ADTRAN AOS Version R10.1.0 Command Reference Manual page 490

Command Reference Guide
LBRs Received: 30
LBRs with bad data: 0
Next LTM ID: 1
The following is sample output from the show ethernet cfm mep local fault command:
>enable
#show ethernet cfm mep local fault
MEPs configured on this device
MEP-ID: 3
Domain/Assoc: BenchTest/Test
Mac Address: 00:A0:C9:00:D8:B2 Interface: giga-eth 0/2 Vlan:
Level: 5
Admin State: up
Fault Notification Settings
------------------------------------------------
Highest Allowed Defect: MacStatus
AlarmTime: 2500 ms
SNMP Trap: Disabled
Current Fault State
-------------------------------------
Fault State: Defect Last Reported Fault: 08:41 PM, 09/16/2008
Current Highest Defect: None
Current Defects (Highest to Lowest defect priority):
Xcon CCM: -
Err'd CCM: -
Remote CCM: -
MAC Status: -
RDI:
60000CRG0-35E
LBRs Received Out of Order:
Unexpected LTRs:
Direction: down
CCM State: yes
ResetTime: 10000 ms
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
0
0
0
Priority: 7
490