Show Ip Mroute - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show ip mroute

Use the show ip mroute command to display IP multicasting routing table information. Variations of this
command include:
show ip mroute
show ip mroute all
show ip mroute <ip address>
show ip mroute <interface>
show ip mroute summary
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
all
<ip address>
<interface>
summary
Default Values
No default values are necessary for this command.
60000CRG0-35E
Optional. Displays all multicast routes, including those not used to forward
multicast traffic.
Optional. Displays IP address of a multicast group. IP addresses should be
expressed in dotted decimal notation (for example, 10.10.10.1).
Optional. Specify an interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface id | ap |
ap/radio | ap/radio.vap]>. For example, for a T1 interface, use t1 0/1; for an
Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for an
ATM subinterface, use atm 1.1; and for a wireless virtual access point, use
dot11ap 1/1.1. Type show ip mroute ? for a complete list of interfaces.
Optional. Displays a single-line summary for each entry in the IP multicast
routing table.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
565