ADTRAN AOS Version R10.1.0 Command Reference Manual page 848

Command Reference Guide
voice dsp capture
Use the voice dsp capture command to initiate digital signal processor (DSP) captures. Use the no form of
this command to return to the default setting. Variations of this command include:
voice dsp capture start
voice dsp capture start <value>
voice dsp capture stop
voice dsp capture cancel
Syntax Description
start
<value>
stop
cancel
Default Values
By default, the DSP capture is disabled.
Command History
Release 15.1
Functional Notes
The voice DSP captures are used to help diagnose voice issues. The channel numbers for this command
correspond to those seen in the show and debug commands (for example, the first channel is 1, not 0).
Output is received on all console sessions notifying you of a running DSP capture or download. Closing
the CLI session on which the capture was started will cancel the current capture. This method of DSP
capture is valid on AOS Release 15.1 or later, replacing the en8 int voip 0/1 method.
Usage Examples
The following example starts a DSP capture:
#voice dsp capture start
DSP Slot [0]: 0
DSP Port [1]: 1
DSP Channel [1]:1
%Warning! Performance of this unit may be degraded during a DSP capture!
Continue and start DSP Capture? [y/n] y
DSP UTILITIES. Voice Capture A DSP capture is active on VoIP 0/1 on channel 1dsp capture
60000CRG0-35E
Starts the command line interface (CLI) wizard that prompts the user for the
necessary information to initiate a DSP capture.
Optional. Specifies a DSP capture starting on a specific channel on DSP
0/1. The valid channel number range is 1 to 32.
Stops the current DSP capture and downloads the captured files to FLASH.
Cancels the current DSP capture and discards the captured files.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
848