Table of Contents
Advertisement
Command Reference Guide
ip firewall policy-log threshold <value>
Use the ip firewall policy-log threshold command to specify the number of Internet Protocol version 4
(IPv4) access control policy (ACP) events identified by AOS before generating a log message. Use the no
form of this command to return to the default value.
The AOS IPv4 firewall must be enabled (using the command
the stateful inspection firewall to be activated.
Syntax Description
<value>
Default Values
By default, the ip firewall policy-log threshold is set to 100.
Command History
Release 2.1
Usage Examples
The following example specifies that a log is generated when 150 IPv4 ACP events are detected on the
default VRF:
(config)#ip firewall policy-log threshold 150
60000CRG0-35E
Specifies the number of IPv4 policy events AOS identifies before creating
the log. Valid range is 0 to 4294967295.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
ip firewall on page
999) for
1016
Advertisement
Table of Contents
