ADTRAN AOS Version R10.1.0 Command Reference Manual page 196

Command Reference Guide
copy flash
Use the copy flash command to copy files located in flash memory to a specified destination.
Variations of this command (valid on all AOS units) include:
copy flash tftp
copy flash xmodem
copy flash <source file> http <url> port <port>
copy flash <source file> https <url> port <port>
Variations of this command (valid only on AOS units WITH CompactFlash
copy flash <source file> boot
copy flash <source file> cflash
copy flash <source file> cflash <new file>
copy flash <source file> flash <new file>
copy flash <source file> interface <interface>
copy flash <source file> startup-config
Variations of this command (valid only on AOS units WITH CompactFlash AND voice capability)
include:
copy flash <source file> dynvoice-config
Variations of this command (valid only on AOS units WITH ramdisk enabled) include:
copy flash <source file> ramdisk
copy flash <source file> ramdisk <new file>
Variations of this command (valid only on AOS units WITH Universal Serial Bus (USB) flash drive
capability) include:
copy flash <source file> usbdrive0
copy flash <source file> usbdrive0 <new file>
Variations of this command (valid only on AOS units WITH field-programmable gate arrays (FPGAs))
include:
copy flash <source file> fpga
Syntax Description
<source file>
<new file>
boot
cflash
dynvoice-config
60000CRG0-35E
Specifies the name of the file (located in flash memory) to copy.
Saves the file using the specified file name.
Copies the specified source file and overwrites the boot read only memory
(ROM).
Copies a file and saves it to the CompactFlash card.
Replaces the dynamic voice configuration file with the specified file copied
from flash memory.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
®
capability) include:
196