Table of Contents
Advertisement
Command Reference Guide
ip firewall attack-log threshold <number>
Use the ip firewall attack-log threshold command to specify the number of possible attack conditions
AOS will identify and block before generating a log message when using Internet Protocol version 4
(IPv4). Use the no form of this command to return to the default threshold.
The AOS IPv4 firewall must be enabled (using the command
the stateful inspection firewall to be activated.
Syntax Description
<number>
Default Values
By default, the ip firewall attack-log threshold is set at 100.
Command History
Release 2.1
Usage Examples
The following example specifies a threshold of 25 attacks before generating a log message for the IPv4
firewall:
(config)#ip firewall attack-log threshold 25
60000CRG0-35E
Specifies the number of possible attack conditions AOS IPv4 will identify
before generating a log message. Valid range is 0 to 4294967295.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
ip firewall on page
999) for
1007
Advertisement
Table of Contents
