Show Gvrp Statistics - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show gvrp statistics

Use the show gvrp statistics command to show statistics related to GARP VLAN Registration Protocol
(GVRP). Variations of this command include:
show gvrp statistics
show gvrp statistics interface <interface>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
interface <interface>
Default Values
No default values are necessary for this command.
Command History
Release 8.1
Release 17.1
Usage Examples
The following example displays statistics related to GVRP for Ethernet interface 0/24:
>enable
#show gvrp statistics interface ethernet 0/24
Name: eth 0/24
Join Empty Received: 0
Join In Received: 272
Empty Received: 30
Leave Empty Received: 0
--MORE--
60000CRG0-35E
Optional. Shows the information for the specified interface. Specify an
interface in the format <interface type [slot/port | slot/port.subinterface id |
interface id | interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For
example, for a T1 interface, use t1 0/1; for an Ethernet subinterface, use
eth 0/1.1; for a PPP interface, use ppp 1; for an ATM subinterface, use
atm 1.1; and for a wireless virtual access point, use dot11ap 1/1.1. Type
show gvrp statistics interface ? for a complete list of applicable
interfaces.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
510