ADTRAN AOS Version R10.1.0 Command Reference Manual page 197

Command Reference Guide
flash
fpga
http <url>
https <url>
interface <interface>
port <port>
ramdisk
startup-config
tftp
usbdrive0 <new file>
xmodem
Default Values
No default values are necessary for this command.
Command History
Release 1.1
Release 16.1
60000CRG0-35E
Copies the specified file and saves it to flash memory.
Copies the specified file and saves it as the FPGA image.
Copies the specified source file and transfers it to a Hypertext Transfer
Protocol (HTTP) server using the specified HTTP server uniform resource
locator (URL). Use HTTP PUT operation.
Copies the specified source file and transfers it to a secure socket
Hypertext Transfer Protocol Secure (HTTPS) server using the specified
HTTPS server URL. Use HTTPS PUT operation.
Updates the specified interface using a copy of the specified file. Specify an
interface in the format <interface type [slot/port | slot/port.subinterface id |
interface id | interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For
example, for a T1 interface, use t1 0/1; for an Ethernet subinterface, use
eth 0/1.1; for a PPP interface, use ppp 1; for an ATM subinterface, use
atm 1.1; and for a wireless virtual access point, use dot11ap 1/1.1. Type
copy flash <source file> interface ? to display a list of valid interfaces.
Optional. Specifies the port used to transfer the specified file to an HTTP or
HTTPS server. Range is 0 to 65335.
Copies a file and saves it to the volatile RAM disk.
Replaces the startup configuration file with a copy of the specified file.
Copies any file located in flash memory to a specified Trivial File Transfer
Protocol (TFTP) server.
After entering copy flash tftp, AOS prompts for the following information:
Address of remote host: Specifies the IP address of the TFTP server.
Source filename:
Destination filename:
Copies the specified file and saves it to USB flash drive memory.
Copies any file located in flash memory (using the XMODEM protocol) to
the terminal connected to the console port. XMODEM capability is provided
in VT100 terminal emulation software, such as HyperTerminal.
After entering copy flash xmodem, AOS prompts for the following
information:
Source filename:
Command was introduced.
Command was expanded to include HTTP and HTTPS.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
Specifies the name of the file (located in flash
memory) to copy to the TFTP server.
Specifies the file name to use when storing the
copied file on the TFTP server. (The file will be
placed in the default directory established by the
TFTP server.)
Specifies the name of the file to copy from system
flash memory using XMODEM.
197