ADTRAN AOS Version R10.1.0 Command Reference Manual page 989

Command Reference Guide
ip default-gateway <ip address>
Use the ip default-gateway command to specify a default gateway on a switch or on a router if (and only
if) IP routing is NOT enabled on the router. Use the ip route command to add a default route to the route
table when using IP routing functionality. Refer to
form of this command to disable this feature.
Syntax Description
<ip address>
Default Values
By default, there is no configured default gateway.
Command History
Release 1.1
Usage Examples
The following example disables IP routing on a router and configures a default gateway for 10.10.10.1:
(config)#no ip routing
(config)#ip default-gateway 10.10.10.1
The following example specifies a default gateway for the management interface on a switch:
(config)#ip default-gateway 10.10.10.1
60000CRG0-35E
ip route on page 1070
Specifies the default gateway IP address. IP addresses should be
expressed in dotted decimal notation (for example, 10.10.10.1).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
for more information. Use the no
989