ADTRAN AOS Version R10.1.0 Command Reference Manual page 186

Command Reference Guide
copy
Use the copy command to copy the specified file from the source (flash memory) to the specified
destination.
Variations of this command (valid only on AOS units WITHOUT CompactFlash
copy <source file> <new file>
copy <source file> boot
copy <source file> default-config
copy <source file> fpga
copy <source file> interface <interface>
copy <source file> startup-config
Syntax Description
<source file>
<new file>
boot
default-config
fpga
interface <interface>
startup-config
Default Values
No default values are necessary for this command.
Command History
Release 1.1
Release 16.1
Release 17.2
Release A4.01
60000CRG0-35E
Specifies the name of the file to copy.
Makes a copy of the specified source file and saves it in flash memory using
the specified new name.
Copies the specified source file and overwrites the boot read only memory
(ROM).
Replaces the default configuration with the specified file copied from flash
memory.
Updates the field-programmable gate array (FPGA) using a copy of the
specified file.
Updates the specified interface using a copy of the specified file. Specify an
interface in the format <interface type [slot/port | slot/port.subinterface id |
interface id | interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For
example, for a T1 interface, use t1 0/1; for an Ethernet subinterface, use
eth 0/1.1; for a PPP interface, use ppp 1; for an ATM subinterface, use
atm 1.1; and for a wireless virtual access point, use dot11ap 1/1.1. Type
copy <source file> interface ? to display a list of valid interfaces.
Replaces the startup configuration with the specified file copied from flash
memory.
Command was introduced.
Command was expanded to include the default-config.
Command was expanded to include the cellular interface.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
®
) include:
186