ADTRAN AOS Version R10.1.0 Command Reference Manual page 509

Command Reference Guide
show gvrp state vlan <vlan id> interface <interface>
Use the show gvrp state vlan interface command to display the GARP VLAN Registration Protocol
(GVRP) state.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<vlan id>
<interface>
Default Values
No default values are necessary for this command.
Command History
Release 17.5
Usage Examples
The following example displays the state of VLAN 200 on switchport interface 0/2:
>enable
#show gvrp state vlan 200 interface switchport 0/2
Port swx 0/2:
Registrar: Empty, Forbidden
Applicant: Very Anxious, Observer
60000CRG0-35E
Specifies the VLAN to display.
Specifies the interface to display. Specify an interface in the format
<interface type [slot/port | slot/port.subinterface id | interface id | interface
id.subinterface id]>. For example, for a T1 interface, use t1 0/1; for an
Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; and
for an ATM subinterface, use atm 1.1. Type interface ? for a complete list
of valid interfaces.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
509