ADTRAN AOS Version R10.1.0 Command Reference Manual page 502

Command Reference Guide
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
page 837).
Usage Examples
The following are sample outputs from various show frame-relay commands:
>enable
#show frame-relay lmi
LMI statistics for interface FR 1 LMI TYPE = ANSI
Num Status Enq. Sent 79
Num Update Status Rcvd 12
>enable
#show frame-relay pvc
Frame Relay Virtual Circuit Statistics for interface FR 1
Active Inactive
local 2 0
DLCI = 16 DLCI USAGE = LOCAL PVC STATUS = ACTIVE INTERFACE = FR 1.16
MTU: 1500
input pkts: 355
out bytes: 115399
in BECN pkts: 0
pvc create time: 00:00:00:12
DLCI = 20 DLCI USAGE = LOCAL PVC STATUS = ACTIVE INTERFACE = FR 1.20
MTU: 1500
input pkts: 0
out bytes: 22384
in BECN pkts: 0
pvc create time: 00:00:01:25
60000CRG0-35E
Num Status Msgs Rcvd 71
Num Status Timeouts 5
Deleted Static
0 2
output pkts: 529
dropped pkts: 13
in DE pkts: 0
last time pvc status changed: 00:00:13:18
output pkts: 44
dropped pkts: 11
in DE pkts: 0
last time pvc status changed: 00:00:13:18
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
terminal length <number> on
in bytes: 23013
in FECN pkts: 0
out DE pkts: 0
in bytes: 0
in FECN pkts: 0
out DE pkts: 0
502