ADTRAN AOS Version R10.1.0 Command Reference Manual page 388

Command Reference Guide Enable Mode Command Set
factory-default
Use the factory-default command to reset the unit to the factory default setting.
Performing an AOS factory-default disrupts data traffic.
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 5.1 Command was introduced.
Functional Notes
After you issue this command, the system responds by first warning you that restoring the factory default
settings will erase the current configurations. It then asks if you would like to proceed. Choose n to return
to the command prompt (no configuration changes are made). Choose y to erase the
startup-configuration, replace it with the factory-default configuration, and reboot the unit. After reboot, the
new configuration takes effect.
Usage Examples
The following example resets the unit to the factory default settings:
>enable
#factory-default
WARNING - Restoring the factory default settings will erase the current startup and running configurations
and will reboot the unit.
Restore factory default settings?[y/n]y
Startup configuration written.
Rebooting the system. Please wait...
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 388