ADTRAN AOS Version R10.1.0 Command Reference Manual page 421

Command Reference Guide
show audit security
Use the show audit security command to display the results of the security audit including: the type of
defect, severity, and a brief description. The security audit must be initiated first using the command
audit security on page 409. Variations of this command include:
show audit security
show audit security detail
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
detail
Default Values
No default values are necessary for this command.
Command History
Release 17.7
Functional Notes
The security audit tool is used to identify possible security violations and is initiated by using the command
run audit security on page
The show audit security detail command lists a summary of the results, as well as details of the defect
and recommends corrective action. It is up to the customer to determine if the findings are a true risk in
their system, and to make the necessary adjustments to their configuration. Some items could be recorded
as possible risks that are not actual risks based on the entire network configuration.
Usage Examples
The following is sample output from the show audit security command:
>enable
#show audit security
Using 2214 bytes
**SUMMARY**
60000CRG0-35E
Optional. Displays the details of the security audit and recommends
corrective action.
Command was introduced.
409.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
run
421