Show Ip Igmp Groups - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show ip igmp groups

Use the show ip igmp groups command to display the multicast groups that have been registered by
directly connected receivers using Internet Group Management Protocol (IGMP). If no multicast group IP
address is specified, all groups are shown with this command. Variations of this command include:
show ip igmp groups
show ip igmp groups <multicast address>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<multicast address>
Default Values
No default values are necessary for this command.
Command History
Release 7.1
Release 17.1
Usage Examples
The following is sample output from this command:
>enable
#show ip igmp groups
IGMP Connected Group Membership
Group Address Interface
172.0.1.50 Loopback100
172.1.1.1 Ethernet0/1
172.1.1.1 Loopback100
60000CRG0-35E
Optional. Displays the IP address of a multicast group. The multicast group IP
address range is 244.0.0.0 to 239.255.255.255 or 224.0.0.0 /4.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Uptime Expires
00:42:57 00:02:50
00:05:26 00:02:51
00:42:57 00:02:51
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
Last Reported
172.23.23.1
1.1.1.2
172.23.23.1
556