ADTRAN AOS Version R10.1.0 Command Reference Manual page 715

Command Reference Guide
show queuing
Use the show queuing command to display information associated with configured queuing methods.
Variations of this command include:
show queuing
show queuing fair
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
fair
Default Values
No default values are necessary for this command.
Command History
Release 5.1
Release 17.1
Usage Examples
The following is sample output from the show queuing command:
>enable
#show queuing
Interface Discard threshold
fr 1 64
fr 2 64
ppp 1 64
60000CRG0-35E
Optional. Displays only information on the weighted fair queuing (WFQ)
configuration.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Conversation subqueues
256
256
256
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
715