ADTRAN AOS Version R10.1.0 Command Reference Manual page 726

Command Reference Guide
show running-config ipv6
Use the show running-config ipv6 command to display all the nondefault parameters contained in the
current Internet Protocol version 6 (IPv6) running configuration file. Specific portions of the running
configuration may be displayed, based on the command entered. Variations of this command include the
following:
show running-config ipv6 access-lists
show running-config ipv6 access-lists verbose
show running-config ipv6 dhcp pool <name>
show running-config ipv6 dhcp pool <name> verbose
show running-config ipv6 policy-class
show running-config ipv6 policy-class verbose
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
access-lists
dhcp pool <name>
policy-class
verbose
Default Values
No default values are necessary for this command.
Command History
Release 18.1
Release 18.3
60000CRG0-35E
83.
Displays the current running configuration for all configured IPv6
access control lists (ACLs).
Displays the current running configuration for the specified
Dynamic Host Control Protocol version 6 (DHCPv6) server
address pool.
Displays the current running configuration for all configured IPv6
access control policies (ACPs).
Optional. Displays the entire running configuration to the terminal
screen (versus only the nondefault values).
Command was introduced.
Command was expanded to include the dhcp pool parameter.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
726