ADTRAN AOS Version R10.1.0 Command Reference Manual page 688

Command Reference Guide
show output-chkdsk
Use the show output-chkdsk command to display output from the CFLASH checkdisk that occurs at boot
up. File allocation table (FAT) errors detected or repaired are shown from the last boot up using this
command. If checkdisk passed without incident, the command displays the output File is empty. This
command is only applicable to ADTRAN integrated communications products (ICPs).
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 14.1
Release 17.1
Usage Examples
The following is sample output from the show output-chkdsk command where checkdisk passed:
>enable
#show output-chkdsk
File is empty.
The following is sample output from the show output-chkdsk command where errors were detected and
repaired. An explanation of the errors found follows the output:
>enable
#show output-chkdsk
## 'SystemDefaultPrompts' The '.' entry has a non-zero size (repaired).
## 'SystemDefaultPrompts' The '..' entry points to cluster 2 (should be root directory - repaired).
## Cluster 583 chains to 435, but 583 is already used in another chain.
## Terminated subsequent instance of cross-linked chain starting at 205 at cluster 394.
## 'VoiceMail' The '.' first entry was not found.
## 'VoiceMail' Found 2 checksum mismatches (repaired).
## 'VoiceMail/Messages' Found 3 trailing entries (repaired).
## 'VoiceMail' Found 2 duplicate entries (repaired).
60000CRG0-35E
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
688