ADTRAN AOS Version R10.1.0 Command Reference Manual page 271

Command Reference Guide
debug hw-access-list <name>
Use the debug hw-access-list command to activate debug messages that display traffic matches logged by
the named hardware access control list (ACL). Use the no form of this command to disable the debug
messages.
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
<name>
Default Values
By default, all debug messages in AOS are disabled.
Command History
Release 17.6
Functional Notes
The debug hw-access-list <name> command displays data gathered by a configured hardware ACL. The
specified hardware ACL must have logging enabled to populate the debug message. For more information
on hardware ACLs and event match logging, refer to the
on page 3109.
Only hardware ACL debug messages can be displayed using this command. If you enter a
software ACL name in this command, you will receive an error message.
Usage Examples
Enter the command as follows to enable debug messages for the hardware ACL ADTN:
>enable
#debug hw-access-list ADTN
2009.05.07 11:32:39 ACCESS_LIST.ADTN permit mac 00:a0:c8:00:00:00 00:00:00:ff:ff:ff any log
(44864 matches)
2009.05.07 11:32:45 ACCESS_LIST.ADTN permit mac 00:a0:c8:00:00:00 00:00:00:ff:ff:ff any log
(106 matches)
2009.05.07 11:32:49 ACCESS_LIST.ADTN permit mac 00:a0:c8:00:00:00 00:00:00:ff:ff:ff any log
(90 matches)
60000CRG0-35E
Specifies the name of the hardware ACL.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
Hardware ACL and Access Map Command Set
271