Show Temperature - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show temperature

Use the show temperature command to display the unit temperature.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 7.1
Release 17.1
Usage Examples
The following is sample output from the show temperature command:
>enable
#show temperature
Temperature: 33 degrees C
60000CRG0-35E
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
770