ADTRAN AOS Version R10.1.0 Command Reference Manual page 1186

Command Reference Guide
ipv6 dhcp address conflict limit <number>
Use the ipv6 dhcp address conflict limit command to specify the maximum number of conflicting
Internet Protocol version 6 (IPv6) addresses that can be stored by the Dynamic Host Control Protocol
version 6 (DHCPv6) server. This command limits the number of conflicting addresses stored by the
DHCPv6 server to ensure that the AOS unit does not run out of memory. Use the no form of this command
to reset the count to the default value.
Syntax Description
<number>
Default Values
By default, only a certain number of conflicting IPv6 addresses can be stored. This number varies by AOS
product.
Command History
Release R10.1.0
Usage Examples
The following example changes the number of conflicting IPv6 addresses stored by the DHCPv6 server to
3500:
(config)#ipv6 dhcp address conflict limit 3500
60000CRG0-35E
Specifies the maximum number of conflicting IPv6 addresses that can be
stored by the server. Valid range is 1 to 10000 addresses. This maximum
number is product-specific and is equivalent to the default value on the
product.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1186