ADTRAN AOS Version R10.1.0 Command Reference Manual page 682

Command Reference Guide
show name-server
Use the show name-server command to display the current domain naming system (DNS) name server's
address and the source of its addresses. Address sources include Dynamic Host Control Protocol version 4
(DHCPv4), DHCP version 6 (DHCPv6), Point-to-Point Protocol and Internet Protocol Control Protocol
(PPP-IPCP), and user configured addresses. Variations of this command include:
show name-server
show name-server realtime
show name-server vrf <name>
show name-server vrf <name> realtime
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
realtime
vrf <name>
Default Values
No default values are necessary for this command.
Command History
Release 18.3
60000CRG0-35E
Optional. Displays the name server information in real time.
Optional. Specifies a nondefault VPN routing and forwarding (VRF) instance
for which to display name server address information. If a VRF instance is
not specified, name server information for the default VRF instance is
displayed.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
682