ADTRAN AOS Version R10.1.0 Command Reference Manual page 397

Command Reference Guide
Release A5.01
Functional Notes
The ping ethernet command can be issued from both the Basic and Enable modes.
If the MEP ID is used as the target, the remote MEP must exist in the MEP continuity check message
(CCM) database (meaning the remote MEP is transmitting valid CCMs) so that the MEP ID can be
translated to the MAC address before the loopback message is transmitted.
Both the domain <domain name> and association <association name> parameters are not required if the
source MEP ID of the MEP is specified and unique through the AOS device.
If the domain and association of the transmitting MEP are specified, and there is only one MEP in that
domain or association, or if there is only one MEP configured on the unit, the mep <mep id> parameter is
not required.
For more information regarding Ethernet OAM CFM and its operation on AOS products, refer to the
Ethernet OAM CFM in AOS configuration guide available online at
(article number 3013).
This command will not appear in the command line interface (CLI) unless Ethernet OAM
CFM is enabled. To enable Ethernet OAM CFM, refer to the command
page 943.
Usage Examples
The following example initiates the Ethernet ping utility from an MEP in Domain1 association MA1 with a
destination to an MEP with an MEP ID of 201:
>enable
#ping ethernet 201 domain Domain1 association MA1
Type CTRL+C to abort.
Legend: '!' = Success, '*' = Request timed out, 'd' = Data Mismatch
'o' = Out of order, '.' = No reply, 'e' = Unknown error.
Sending 5, 100-byte LBRs to MEP 201 from MEP 1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 202/668/1011 ms
60000CRG0-35E
Command was expanded to include the Gigabit Ethernet
interface.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
https://supportforums.adtran.com
ethernet cfm on
397