ADTRAN AOS Version R10.1.0 Command Reference Manual page 833

Command Reference Guide
telnet
Use the telnet command to open a Telnet session (through AOS) to another system on the network.
Variations of this command include the following:
telnet <ip address | hostname>
telnet <ip address | hostname> port <tcp port>
telnet vrf <name> <ip address | hostname>
telnet vrf <name> <ip address | hostname> port <tcp port>
Syntax Description
<ip address | hostname>
port <tcp port>
vrf <name>
Default Values
No default values are necessary for this command.
Command History
Release 1.1
Release 14.1
Release 16.1
Functional Notes
VRF on AOS products allows a single physical router to be partitioned into multiple virtual routers. Each
router instance has its own route table and interface assignments. Beginning with Release 16.1, all AOS
routers supporting multiple VRF instances (multi-VRF) have an unnamed default VRF instance regardless
of whether multi-VRF is configured. Therefore, executing the abovementioned commands without
specifying a VRF will only affect the default unnamed VRF.
Usage Examples
The following example opens a Telnet session with a remote system (10.200.4.15):
>enable
#telnet 10.200.4.15
User Access Login:
Password:
60000CRG0-35E
Specifies the IP address or host name of the remote system. IP addresses
should be expressed in dotted decimal notation (for example, 10.10.10.1).
Optional. Specifies the Transmission Control Protocol (TCP) port number to
be used when connecting to a host through Telnet. Range is 1 to 65535.
Optional. Specifies the VPN routing and forwarding (VRF) where the IP
address or host name exists.
Command was introduced.
Command was expanded to specify the port number.
Command was expanded to include the vrf parameter.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
833