ADTRAN AOS Version R10.1.0 Command Reference Manual page 1030

Command Reference Guide
ip ftp server
Use the ip ftp server command to enable the File Transfer Protocol (FTP) server and optionally specify
the default location for the FTP server to store and retrieve files. Use the no form of this command to
disable the FTP server. Variations of this command include:
ip ftp server
ip ftp server default-filesystem cflash
ip ftp server default-filesystem flash
ip ftp server default-filesystem ramdisk
ip ftp server default-filesystem usbdrive0
Syntax Description
default-filesystem
cflash
flash
ramdisk
usbdrive0
Default Values
By default, the ip ftp server default-filesystem is set to flash.
Command History
Release 13.1
Release 17.7
Release 18.2
Usage Examples
The following example enables the FTP server:
(config)#ip ftp server
The following example specifies cflash file system as the default:
(config)#ip ftp server default-filesystem cflash
60000CRG0-35E
Specifies the default file system for the FTP server to use.
Optional. Specifies the FTP server use the CompactFlash
default file system.
Optional. Specifies that the FTP server use the system flash as the default
file system.
Optional. Specifies that the FTP server use the volatile RAM disk as the
default file system.
Optional. Specifies that the FTP server use the Universal Serial Bus (USB)
flash drive as the default file system.
Command was introduced.
Command was expanded to include the ramdisk parameter.
Command was expanded to include the usbdrive0 parameter.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
®
card as the
1030