ADTRAN AOS Version R10.1.0 Command Reference Manual page 970

Command Reference Guide
http secure-server
Use the http secure-server command to enable the Hypertext Transfer Protocol (HTTP) secure (HTTPS)
server and specify the server use secure sockets layer (SSL) version 3. Use the no form of this command to
disable the HTTP server. Variations of this command include:
http secure-server
http secure-server allow-sslv2
http secure-server <TCP port>
http secure-server <TCP port> allow-sslv2
Syntax Description
allow-sslv2
<TCP port>
Default Values
By default, the HTTP secure server is disabled. When the HTTP secure server is enabled, it uses SSLv3
by default.
Command History
Release 3.1
Release 17.6
Release 18.3
Release R10.1.0
Usage Examples
The following example enables the HTTP secure server:
(config)#http secure-server
60000CRG0-35E
Optional. Allows the server to fall back to SSLv2 if it is unable to connect
using SSLv3.
Optional. Specifies an alternate Transmission Control Protocol (TCP) port to
use for HTTPS connections.
Command was introduced.
Command was expanded to include the allow-sslv2 parameter.
Command syntax was changed to remove the ip keyword for IPv6 support
in ADTRAN internetworking products.
Command syntax was changed to remove the ip keyword for ADTRAN
voice products.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
970