ADTRAN AOS Version R10.1.0 Command Reference Manual page 1052

Command Reference Guide
ip mgcp retransmit-delay
Use the ip mgcp retransmit-delay command to specify the constant time between retransmissions of
Media Gateway Control Protocol (MGCP) messages. Use the no form of this command to return to the
default setting. Variations of this command include:
ip mgcp retransmit-delay 100ms
ip mgcp retransmit-delay 250ms
ip mgcp retransmit-delay 500ms
ip mgcp retransmit-delay 1sec
ip mgcp retransmit-delay 2sec
ip mgcp retransmit-delay 4sec
Syntax Description
100ms
250ms
500ms
1sec
2sec
4sec
Default Values
By default, retransmissions occur with longer and longer delays between retransmissions. These delays
are based on RFC 3435, which uses a User Datagram Protocol (UDP) back-off algorithm for MGCP
retransmission delay.
Command History
Release A2
Usage Examples
The following example specifies that retransmissions will occur at a constant rate of 1sec:
(config)#ip mgcp retransmit-delay 1sec
60000CRG0-35E
Specifies 100 milliseconds between retransmissions.
Specifies 250 milliseconds between retransmissions.
Specifies 500 milliseconds between retransmissions.
Specifies 1 second between retransmissions.
Specifies 2 seconds between retransmissions.
Specifies 4 seconds between retransmissions.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1052