ADTRAN AOS Version R10.1.0 Command Reference Manual page 979

Command Reference Guide
interface mef-ethernet <slot/port>
Use the interface mef-ethernet command to enter the Metro Ethernet Forum (MEF) Ethernet Interface
Configuration mode.
Syntax Description
<slot/port>
Default Values
No default values are necessary for this command.
Command History
Release A4.01
Functional Notes
The MEF Ethernet interface is a virtual interface that provides connection between the Ethernet in the first
mile (EFM) network interface module (NIM2) and the AOS unit.
If you are using 802.1q encapsulation, you must have a native VLAN MEF Ethernet subinterface
configured for the EFM NIM2 to communicate with the AOS unit.
For more information about the MEF Ethernet interface, refer to
more information about the configuration of EFM NIM2s and the MEF Ethernet interface, refer to the
Configuring EFM NIM2s and the MEF Ethernet Interface in AOS configuration guide available online at
https://supportforums.adtran.com.
Usage Examples
The following example enters the configuration mode for MEF Ethernet interface in slot 1 port 1:
(config)#interface mef-ethernet 1/1
60000CRG0-35E
Specifies the slot and port of the MEF Ethernet interface.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
MEF Ethernet Interface on page 1790. For
979