ADTRAN AOS Version R10.1.0 Command Reference Manual page 539

Command Reference Guide
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
page 837).
VRF on AOS products allows a single physical router to be partitioned into multiple virtual routers. Each
router instance has its own route table and interface assignments. Beginning with Release 16.1, all AOS
routers supporting multiple VRF instances (multi-VRF) have an unnamed default VRF instance regardless
of whether multi-VRF is configured. Therefore, executing the abovementioned commands without
specifying a VRF will only affect the default unnamed VRF.
Usage Examples
The following is sample output from the show ip arp command:
>enable
#show ip arp
ADDRESS TTL(min)
10.22.18.3 19
192.168.20.2 16
224.0.0.5 20
60000CRG0-35E
MAC ADDRESS INTERFACE
00:E0:29:6C:BA:31 eth 0/1
00:A0:C8:0D:E9:AD eth 0/2
01:00:5E:00:00:05 eth 0/2
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
terminal length <number> on
TYPE
Dynamic
Dynamic
Permanent
539