ADTRAN AOS Version R10.1.0 Command Reference Manual page 734

Command Reference Guide
show schedule
Use the show schedule command to display information regarding the schedule configuration.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 15.1
Release 17.1
Usage Examples
The following is sample output from the show schedule command:
>enable
#show schedule
Schedule entry: DELAY-AFTER-BOOT (active)
Schedule entry: DELAY (inactive)
Technology Review
The scheduler provides a method for configuring a feature to operate during a specific time schedule and
to receive feedback when the feature should disable or enable. The goal of the scheduler is to eliminate
redundant code while providing an understandable, streamlined application program interface (API) for
rapid feature development with schedules. The show schedule command displays how many features are
scheduled and whether they are active or inactive.
60000CRG0-35E
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
734